Contents

Fernbedienung manual

  1. 1. Installing

    This chapter puts Fernbedienung on an M-VAVE FM-1 and takes it off again. You install from a web page in Chrome or Edge on a computer, not on the iPad or iPhone, and you can go back to M-VAVE's official firmware the same way. If an install goes wrong, see If something goes wrong.

  2. 2. Connecting

    This chapter connects the FM-1 to Steckfeld SF1 on an iPad or iPhone. One USB-C cable carries everything: the keys, knobs and buttons go to Steckfeld as MIDI, Steckfeld's screen comes back to the FM-1, and Steckfeld's sound plays through the FM-1's audio output.

  3. 3. Controls

    This chapter goes through every key, knob and button on the FM-1 and what it does in Steckfeld SF1. Steckfeld decides what each control does on the page you have open, so some controls do nothing on some pages. To use the FM-1 with other apps, see Advanced.

  4. 4. Screens

    This chapter explains what the FM-1's screen shows: the Edit screen of a part, the Route screen with its cables, the patch list, the macro, notices, the FM-1's own settings and the messages it shows before Steckfeld SF1 answers.

  5. 5. Audio interface

    This chapter covers the FM-1 as Steckfeld SF1's audio output. The USB-C cable that carries the controls also carries the sound, so you plug headphones or a mixer into the FM-1. On an iPhone, with its single port, that gives you a controller and wired headphones without a hub.

  6. 6. Settings

    This chapter covers the FM-1's own settings: the MIDI channel, velocity and OPEN on the EDIT page, and the button lights and theme in the system settings. Steckfeld SF1 never changes these; you set them on the FM-1, and the FM-1 tells Steckfeld.

  7. 7. Troubleshooting

    This chapter lists problems you may run into with the FM-1 and Steckfeld SF1, and what to do about them. Install problems are in Installing. The FM-1's recovery modes are in Advanced.