Contents

Beiwagen manual

  1. 1. Installing

    This chapter puts Beiwagen on an M-VAVE FM-1 and takes it off again. You install from a web page in Chrome or Edge on a computer, and you can go back to M-VAVE's official firmware the same way. If an install goes wrong, see If something goes wrong.

  2. 2. Connecting to the OP-1 field

    Beiwagen works with a teenage engineering OP-1 field and one USB cable between the two. The OP-1 sends its four tape tracks to the FM-1, records what the FM-1 sends back, and receives notes from the FM-1's keys. This chapter covers the cable, the OP-1's settings and how to tell the connection works. What has been tested on real hardware is listed in What is tested.

  3. 3. Controls and screen

    This chapter lists what every button, knob and key on the FM-1 does in Beiwagen, the button combinations, and how the screen is laid out. Beiwagen is organised in four sections (HOME, mixer, sequencer, arpeggiator). Each has its own button and a few pages, and the four knobs under the screen always change what the current page shows.

  4. 4. HOME

    Press HOME to see what the OP-1 sends and to set up the keyboard. HOME has four pages, in this order: Tracks, Keys, USB and Scope. Turn SELECT to move between them.

  5. 5. Mixer

    Press GLO to open the mixer. It takes all four OP-1 tape tracks, gives each a level, a pan, a filter with drive and two sends, adds a shared delay and reverb, and sends one stereo mix back to the OP-1. The usual job is a bounce: tracks 1 to 3 with effects, recorded onto track 4. The mixer is built but has not been tested on an FM-1 yet.

  6. 6. Sequencer and arpeggiator

    Beiwagen has a step sequencer and an arpeggiator. Both play the OP-1 over USB-MIDI, at their own tempo or following the OP-1's MIDI clock. Press SEQ for the sequencer and ARP for the arpeggiator. Both are built but have not been tested on an FM-1 yet.

  7. 7. Presets and patterns

    Beiwagen stores mixer settings and sequencer patterns on the 27 keys. Hold SAVE and press a key to store, hold SEL and press a key to load. Outside the sequencer the keys hold mixer presets, in the sequencer they hold patterns, and the two never mix. This is built but has not been tested on an FM-1 yet.

  8. 8. Settings

    The system settings hold what belongs to the FM-1 itself rather than to a preset. In Beiwagen 0.2 that is one setting: the brightness of the button lights. The settings are built but have not been tested on an FM-1 yet.

  9. 9. Troubleshooting

    This chapter lists problems by what you see, with the likely cause and the fix. Installer messages are in Install errors.