Contents

Presets and patterns

Beiwagen stores mixer settings and sequencer patterns on the 27 keys. Hold SAVE and press a key to store, hold SEL and press a key to load. Outside the sequencer the keys hold mixer presets, in the sequencer they hold patterns, and the two never mix. This is built but has not been tested on an FM-1 yet.

Store a preset

  1. Set up the mixer the way you want it.
  2. Outside the sequencer, hold SAVE. The footer says Save preset: press a key, and the key LEDs show which keys already hold a preset.
  3. Press a key. The footer says Saved to key N. Whatever was on that key before is replaced.
  4. Let go of SAVE.

If you let go of SAVE without pressing a key, nothing is saved.

A preset holds every mixer setting: levels, pans, sends, filters, mutes, the delay, the reverb and the Master page. It does not hold the return track, because that depends on which track is selected on the OP-1.

Load a preset

  1. Outside the sequencer, hold SEL. The footer says Load preset: press a key, and the key LEDs show which keys hold a preset.
  2. Press a key. The footer says Loaded key N, and the mixer changes to the stored settings.

Levels ramp to their new values, so loading a preset while the tape plays doesn't click. The return track stays as it was.

Store and load a pattern

In the sequencer the same gestures work on the pattern you are editing (the one shown as P1 to P27 in the header):

# Gesture What happens Footer
1 Hold SAVE, press a key The pattern is stored on the key. Saved to key N
2 Hold SEL, press a key The stored pattern replaces the pattern you are editing. Loaded key N

The pattern's number and its slot on a key are separate: pattern 3 can be stored on key 12, and loaded back into pattern 7.

Save the session

Hold SAVE for 2 seconds without pressing a key. The footer says Session saved. The session is the current mixer and the pattern you are editing. Both come back the next time you switch on the FM-1: the mixer settings, and the pattern as pattern 1.

Beiwagen does not save the session by itself. Save it before you switch off if you want to keep what you set up.

Messages

# Footer Meaning
1 Key N is empty Nothing is stored on that key. Nothing changed.
2 Stop playback to save The sequencer is playing, and saving is refused while it plays. Press PLAY to stop, then save again.
3 From newer firmware The key or the store was written by a newer Beiwagen. It is left alone.
4 Flash error, not saved Writing failed. The previous contents are still there.

What is stored where

# What Where How it is saved
1 Mixer presets On keys 1 to 27 Hold SAVE, press a key
2 Patterns On keys 1 to 27, separate from presets Hold SAVE in the sequencer, press a key
3 Session (mixer and edited pattern) Comes back at power-on Hold SAVE for 2 seconds
4 Keyboard MIDI channel and velocity Comes back at power-on By itself when you leave HOME's Keys page
5 Button light brightness Comes back at power-on By itself when you close the settings
6 Return track, octave, tempo, sync, clock out, arpeggiator Not saved

Advanced

For when you know the basics. You don't need this to get started. Skip to Settings

Go back to an older Beiwagen

A newer Beiwagen loads presets and patterns saved by an older one; settings that didn't exist then start at their defaults. The other way round doesn't work: an older Beiwagen won't load a preset or pattern saved by a newer one, says From newer firmware and leaves it alone. It may also refuse to save until you install the newer version again.